This machine is our smallest in the Eagle threader series.  An Eagle V will run parts as small as #6 (.135 diameter) and as large as 3/8" diameter at rates up to 300 parts per minute with a 10 to 20 HP motor.  It will accept dies up to 3-1/8" wide and has a standard blank length up to 48" long.  Like our other Eagles, the Eagle V is built tough with constant torque, a direct drive hydraulic system and UL approved electrical controls.  It too, can be built as a single or double-end unit, and can be customized to accept part length exceeding 48".  This unit can also be used to roll a knurl on your parts.

Used in production of:

• Ball float connecting rods
• Toy axles
  Small U-bolts
• Anchor bolts
• Automotive linkages
• Houseware products
• Furniture
• Major appliances
• Many other uses